How do you check the prompt and setting parameters of an image generated by Stable Diffusion?
Do you ‘open the PING Info tab and load the image’?
Actually, you can check it simply by right-clicking the image file, opening Properties, and going to the Details tab.
Methods for Checking Prompts and Setting Parameters
All prompts and setting parameters are recorded in the image. Let’s take a look at how to do it right away.
- Right-click on the image file
- Open Properties (Alt + Enter)
- Open the Details tab (Press and hold Ctrl, then continuously click Tab until you reach the desired tab)
When you do this, the prompts and setting data will be displayed in the comments section. Also, line breaks and blank lines are accurately reflected.
The image below shows the text from the ‘Comments’ section, which has been selected in full and pasted into Notepad. You can see that everything, including the prompt, negative prompt, and setting parameters, is all listed.
As a test, if you cut the information using Ctrl + X and then close the Properties, the information will be lost.
Even if you load that image into Stable Diffusion’s PING Info, the prompts and setting data will not be displayed.
In such a situation, don’t panic. Try pressing Windows key + V.
If it was deleted just moments ago, you can quickly retrieve it from the clipboard history, so no worries.
Paste it back to the original location with Ctrl + V and save it again.
I hope this little tip makes your Stable Diffusion experience more enjoyable and convenient.
